济南铁皮风管加工:风管的加固有哪些方法?
发布人: 发布时间:2024-05-23 20:05:39
1. 风管的加固可采用楞筋、立筋、角钢、扁钢、加固和管内支撑等形式。
1. The reinforcement of air ducts can be done in the form of corrugated bars, vertical bars, angle steel, flat steel, reinforcement, and internal support.
2. 楞筋和楞线的加固,排列应规则,间隔应均匀,板面不应有明显的变形。
2. The reinforcement of corrugated bars and corrugated lines should be arranged in a regular manner, with even intervals, and there should be no obvious deformation on the board surface.
3. 角钢。加固筋的加固,应排列整齐、均匀对称、其高度应小于或等于风管的法兰宽度。角钢、加固筋与风管的铆接应牢固、间距应均匀,不应大于220毫米 。两相交处应连接为一体。
3. Angle steel. The reinforcement bars should be arranged neatly, evenly and symmetrically, and their height should be less than or equal to the flange width of the air duct. The riveting of angle steel, reinforcement bars, and air ducts should be firm and evenly spaced, not exceeding 220 millimeters. The two intersections should be connected as one entity.
4. 管内支撑与风管的固定应牢固,各支撑点之间或与风管的边沿或法兰的间距应均匀,不应大于950毫米。
4. The support inside the pipe and the fixing of the air duct should be firm, and the distance between each support point or the edge or flange of the air duct should be even, not more than 950 millimeters.
5. 中压和高压系统风管的管段,其长度大于1250毫米时,还应有加有加固框补强,高压系统金属风管的单咬中缝,还应有防止咬中胀裂的加固或补强措施。
When the length of the medium pressure and high pressure system air ducts is greater than 1250 millimeters, reinforcement frames should also be added for reinforcement. For the single bite middle seam of the high pressure system metal air duct, reinforcement or reinforcement measures should also be taken to prevent bite swelling and cracking.
以上就是有关:济南铁皮风管加工 的介绍,想了解更多的内容请点击: 我们将会全心全意为您提供满分服务,欢迎您的来电!
The above is an introduction to the processing of Jinan iron sheet air ducts. For more information, please click: We will wholeheartedly provide you with full score service. Welcome to call us!
上一篇:济南通风管道有哪些分类?
下一篇: